FAT Checks for an Automatic Edge Banding Machine

A buyer specifying an automatic edge banding machine should decide up front which checks must pass before shipment, rather than accepting a general demonstration. Start with the material envelope: ask the supplier to run wood panels across the stated 9–60 mm thickness range and edge tape from 0.4–3 mm, and agree which combinations count as pass or fail.

For feed speeds of 16 / 20 / 24 m/min, require a run at each setting and record whether the machine holds the selected speed. For the stated minimum panel size of 120 × 80 mm before special operations, test the smallest panel you actually intend to process and confirm how it is fed and supported.

Build the acceptance test around repeatable checks: sample count, panel and tape dimensions, speed setting, and a clear visual or measured criterion for the finished edge. Ask whether each check is witnessed, recorded, and repeated after any adjustment.

Before requesting a quote, confirm with the supplier which tests they will perform, what pass or fail criteria they propose, what sample materials you must supply, and how results will be documented.