Trialing a Stainless Steel Agitated Reactor With Your Own Liquid
Buyers should require a demonstration using their actual liquid, not a substitute, and define acceptance checks around mixing behavior, agitator speed, and vessel material before ordering a 1,000 L stainless steel agitated reactor.
Ask the supplier to demonstrate the 1,000 L stainless steel agitated reactor with your actual liquid rather than water or a generic substitute. That single decision shapes the rest of the evaluation: a liquid's viscosity and behavior under agitation determine whether the anchor agitator, listed at 50–80 rpm, suits your mixing task, and a trial with the wrong fluid proves little.
In the request for quotation, state the liquid to be used, the batch volume, and the mixing outcome you need to observe. Ask whether the demonstration will run at the low and high ends of the 50–80 rpm range, and how the supplier will show that the contents are uniformly mixed. Confirm whether the trial vessel is 304 or 316L stainless steel and whether it matches the material you intend to order, since the catalog lists both as options and the demonstration should reflect your chosen grade.
For acceptance, agree in advance what you will watch: visible mixing at the vessel walls and bottom, behavior at your intended fill level, and whether the agitator speed can be held steady. If your liquid differs from the trial fluid in any way, ask for a second run or a documented explanation of the difference.
Before requesting a quote, confirm with the supplier which material grade the demonstration unit uses, whether your own liquid can be shipped or handled on site, what volume the trial will use, and how the observed results will be recorded for acceptance.