Demonstrating a Four-Wheel Alignment Machine on Your Own Vehicles
A buyer's guide to planning a four-wheel alignment demonstration using the buyer's own vehicles, with practical checks for camber, caster and toe readings and acceptance criteria.
Ask the supplier to demonstrate the four-wheel alignment machine on one of your own vehicles rather than a showroom car. That single decision turns the demo into evidence: you see how the equipment handles real wheels, real ride heights and the readings your workshop will actually record for camber, caster and toe.
Before the demonstration, agree which vehicle will be used and what a pass looks like. Will the supplier show a before-and-after printout for camber, caster and toe? How long does setup take on your vehicle, and does the machine need specific wheel sizes or adapters? During the session, watch whether the readings repeat when the vehicle is re-measured, and ask the operator to explain any adjustment made. If your fleet includes varied models, ask whether the same procedure applies or whether extra fixtures are needed.
Treat catalog values as reference only; confirm which specifications apply to the model offered.
Before requesting a quote, confirm with the supplier which vehicle and wheel configurations were demonstrated, whether the readings shown were repeatable, what adapters or fixtures are included, and what acceptance criteria will be written into the order.